NuTone VX550 Installation Guide download pdf (Page 7)

MODEL CF361 & CF361F (For Use with

CI370 and 360 Inlets)

3. Refer to Figure 10. Nail bracket to the side of the stud so

that the front edge of the bracket is flush to the front of

the stud. (The bracket may also be nailed to the front

edge of the stud. See face mounting illustrated. For face

mounting, use locating tabs on bracket for proper alignment.)

4. Refer to Figure 11. Remove cardboard from plaster

guard frame. Using four (4) provided screws, attach the

appropriate flanged fitting and inlet seal to back

of inlet.

5. Replace cardboard in plaster guard frame.

MODEL CF329 (For Use

with 330 Inlets)

6. When using Model CF329, glue

elbow to mounting plate. Attach

to stud as shown in Figure 12.

SIDE

MOUNTING

FACE

MOUNTING

MODEL CF361 & CF361F

/8"

/16"

AD0059

FIGURE 10

AD0015

INSTALLATION IN

NEW CONSTRUCTION

WALL INLET ROUGH-IN

Once the locations for the wall inlets have been determined, mount all inlet brackets.

1. Choose the appropriate mounting bracket for the inlet being installed. (See chart)

2. To locate a bracket on a wall stud, measure approximately 18" up from finished floor level. (Height may vary according to

individual preference.)

Rough-In Series

395 396-1 396-3 CI3301RK CI3303RK CF329 CF361 CF361F CI395RK

330 X X X

360 X X X X X

CI335 X

CI358 Rough-in and wall valve sold together

CI370 X X X X X

CI390 X

CI395 X

CI398 X X X

Wall Valve Series

AD0060

FIGURE 11

FIGURE 12

1 2 3 4 5 6 7 8 9 10 11 12 ... 39 40

Comments to this Manuals

No comments

NuTone VX550 Installation Guide Page 7

Comments to this Manuals

Related products and manuals for Vacuum cleaners NuTone VX550