NuTone VX550 Installation Guide download pdf (Page 20)

FLOOR INLET INSTALLATION IN

NEW & EXISTING CONSTRUCTION

Model CI370 or 360 Series Inlets (361 Rough-In)

1. Refer to Figures 41 and 42. After floor inlet location has

been selected, cut a 3

⁄16" x 2

⁄16" square hole in floor.

Center line of inlet must be located at least 2½" from wall

to allow cover to be opened when hose is inserted.

2. Determine direction of tubing and attach appropriate

flanged fitting to mounting bracket with four (4) screws

supplied. Be sure mounting bracket flange does not

interfere with tubing and seal is securely in place.

3. Refer to Figure 43. Position bracket with frame and

flanged fitting assembly into cutout from below and

secure to sub-floor.

4. Refer to Figure 44. Large end of Model 399 extension

sleeve should be cut to length to allow proper seating of

inlet against floor or carpet.

5. Refer to Figure 45. Pull low-voltage 2-conductor wire

through mounting bracket and attach to terminal screws

on back of floor inlet. Cement extension sleeve to Model

CI370 or 360 inlet. Insert extension sleeve through vinyl

gasket in mounting bracket and firmly seat into flanged

fitting.

6. For convenience of operation, floor inlet should be

installed to open back toward wall.

7. Refer to Figure 43. Secure floor inlet in place with two

screws.

MOLDING

WALL

TOP VIEW

/16"

AD0067

FIGURE 41

/2" MIN.

APPROX.

SIDE VIEW

MOUNTING BRACKET

FLANGE

AD0068

FIGURE 42

CUT TO

LENGTH

EXTENSION

SLEEVE

FLANGED

FITTING

MOUNTING

BRACKET

FLANGE

AD0070

FIGURE 44

WALL

INLET

EXTENSION SLEEVE

BRACKETFLANGED FITTING

TUBING

AD0071

FIGURE 45

FLOOR

SUB-FLOOR

/16"

INLET

EXTENSION

FLOOR

INLET

FRAME

MOUNTING

BRACKET

SEAL

FLANGED

FITTING

AD0069

FIGURE 43

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 39 40

Comments to this Manuals

No comments

NuTone VX550 Installation Guide Page 20

Comments to this Manuals

Related products and manuals for Vacuum cleaners NuTone VX550