NuTone VX550 Installation Guide download pdf (Page 22)

IN WALL INSTALLATIONS

Refer to Figure 47.

• ORIGINAL VACPAN can be installed between wall studs

in side walls.

• ORIGINAL VACPAN should be located tight to one side

in stud space.

• Once the ORIGINAL VACPAN location is determined, cut

a 6¾” long x 1¾” high slot in the wall and baseboard to

accept the ORIGINAL VACPAN.

• The 2 x 4 wall bottom plate between the 2 studs must be

removed. This can be achieved from below using a hole saw.

• In new home construction, the bottom wall plate can be

removed directly. A 6¾” length of 2 x 4 can be used as a

temporary rough in block, that will force all trades to

finish around, leaving a slot for the ORIGINAL VACPAN.

• Floor contractor must run flooring under block.

• Run vacuum tube piping and low voltage wire from the

main line to ORIGINAL VACPAN location.

• Access for final piping connections must be made.

Access from Below

If access is available from below, cut an access

hole through the subfloor underneath the wall between

the studs, positioned so that final piping connections can

be made by reaching through the access hole.

Access Through Wall

Access can be made through the finished wall.

Cut a 2 ¾” x 3 ½” access hole, positioned so that final

piping connections can be made by reaching through the

access hole. A generic cover plate can be used to cover

the hole after installation (sold separately).

• Attach low voltage wires to ORIGINAL VACPAN

terminal connections marked “low voltage only”.

• Slide ORIGINAL VACPAN into mounting slot and secure

to wall using two no. 6 screws provided.

• Reach through access hole and make final fitting

connections.

FIGURE 47

ORIGINAL

VACPAN™

IN WALL INSTALLATIONS

COVER PLATE

SV382S

UNIVERSAL

SHORT 90° ELBOW

AH0002A

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 39 40

Comments to this Manuals

No comments

NuTone VX550 Installation Guide Page 22

Comments to this Manuals

Related products and manuals for Vacuum cleaners NuTone VX550