NuTone NSP130 User Manual download pdf (Page 2)

MODEL NSP130

Page 2

CLEANING & MAINTENANCE

For performance, appearance, and health reasons, clean lter,

fan and grease-laden surfaces. Use only a clean cloth and mild

detergent solution on stainless and painted surfaces. Clean all-

metal lters in the dishwasher.

The motor is permanently lubricated and never needs oiling. If

the motor bearings make excessive or unusual noise, replace

the motor with the exact service motor. The impeller should also

be replaced.

Use 120 V, 50 W, shielded halogen bulbs - MR16 or PAR16 with

GU10 base. Purchase bulbs separately.

The grease lters, bottom panel, and blower wheel should be

cleaned frequently. Use a warm detergent solution. The grease

lters and blower wheel are dishwasher safe.

Note: Some minerals, when in contact with dishwasher

soap additives, may cause lters to discolor. This discol-

oration is not covered by the warranty.

PREPARE HOOD LOCATION

SOFFIT

18" - 24" ABOVE

COOKING SURFACE

CABINET

3¼" X 10" DUCT

(For horizontal discharge)

WALL CAP

ROOF CAP

3¼" X 10"

(For vertical

discharge)

HOUSE WIRING

(Top or Back of hood)

HOODHOOD

1 Determine whether hood will discharge vertically or hori-

zontally. For vertical or horizontal discharge, run ductwork

between the hood location and a roof cap or wall cap. For

best results, use a minimum number of transitions and

elbows.

OPERATION

Always turn the hood ON before cooking in order to establish an

air ow in the kitchen. After turning off the range, let the hood run

for a few minutes to clear the air.

HEAT SENTRY™

The hood is equipped with a Heat Sentry™ thermostat. This safety

device will turn on or speed up the blower if it senses excess heat

above the cooking surface.

If the blower is not on, or if it is running at low speed, the Heat

Senttry™ will override the normal blower control and trun the

blower on the high speed. When the temperature level drops to

normal levels, the blower will return to its original setting.

Operate the hood as follows:

BLOWER SWITCH

This 3-position switch turns blower ON and OFF and controls

blower speed.

Set switch to (1) position to turn blower ON to low speed.

Set switch to (2) position to turn blower ON to high speed.

Set switch to (0) position to turn blower OFF.

LIGHT SWITCH

This 3-position switch turns lights ON and OFF and controls

their intensity.

Set switch to (1) position to turn lights ON to low intensity.

Set switch to (2) position to turn lights ON to high intensity.

Set switch to (0) position to turn lights OFF.

1 2 3 4 5 6 7 ... 15 16

Comments to this Manuals

No comments

NuTone NSP130 User Manual Page 2

Comments to this Manuals

Related products and manuals for Cooker hoods NuTone NSP130