NuTone CFO52BQ Installation Guide download pdf (Page 6)

MODELS CFO52BQ • CFO52WB • CFO52WH

Page 6

ATTACH FAN BLADES

Caution: Remove 5 rubber packing mounts and discard before

installation.

Your fan is equipped with 2-sided reversible blades (except Model

CFO52BQ). Select the finish and install the blade brackets over the

side of the blades that will be visible.

1. Attach the blade to the blade bracket using the screws and fiber

washers as shown in Figure 12. Start screw into bracket. Repeat

for the two remaining screws.

2. Tighten each screw. Make sure the blade is straight.

3. Fasten blade assembly to motor using the screws supplied. (Fig.

12)

4. Attach decorative fob to pull chain.

OPERATION

Turn on the power and check the operation of your fan.

3-SPEED PULL CHAIN

Controls the fan speed as follows: 1 pull - High, 2 pulls - Medium, 3

pulls - Low, and 4 pulls - Off.

Speed settings for warm or cool weather depend on factors such as the

room size, ceiling height, and number of fans.

SLIDE SWITCH

Controls directions: forward (switch down) or reverse (switch up).

NOTE: Wait for fan to stop before changing the setting of the

slide switch.

Warm weather - (Forward) A downward airflow creates a cooling effect

as shown in Fig. 13. This allows you to set your air conditioner on a

warmer setting without affecting your comfort.

Cool weather - (Reverse) An upward airflow moves warm air off the

ceiling area as shown in Fig. 14. This allows you

to s

et your heating

unit on a cooler setting without affecting your comfort.

WALL SWITCH (OPTIONAL)

Your fan is also designed to operate with a wall switch (sold separately).

Refer to wall switch instructions for installation and wiring information.

SCREWS

FIBER

WASHERS

BLADE

BLADE BRACKET

SCREWS

FIGURE 12

FIGURE 13

FIGURE 14

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

Comments to this Manuals

No comments

NuTone CFO52BQ Installation Guide Page 6

Comments to this Manuals

Related products and manuals for Household fans NuTone CFO52BQ