Nutone 672R User Manual

Browse online or download User Manual for Fans Nutone 672R. NuTone 672R User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 6
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
READ & SAVE THESE INSTRUCTIONS!
INSTALLATION INSTRUCTIONS
Exhaust Fan
MODELS: 671R & 672R
The Exhaust Fan consists of the housing, power unit/blower
assembly (motor, wheel, mounting plate), grille and duct collar.
FAN MUST NOT BE INSTALLED IN A CEILING INSULATED
TO A VALUE GREATER THAN R-40.
SUITABLE FOR USE OVER TUB OR SHOWER ENCLOSURE
WHEN INSTALLED IN A GFCI PROTECTED BRANCH CIRCUIT
.
FOR BEST RESULTS
When installing the Exhaust Fan in a new construction site,
install the housing during the rough-in construction. The blower
unit and grille should be installed after the finished ceiling is in
place.
To install the Exhaust Fan in an existing finished building, an
accessible area is required above the planned location (attic or
crawl space).
IMPORTANT SAFETY INSTRUCTIONS
WARNING: TO REDUCE THE RISK OF FIRE. ELECTRIC
SHOCK, OR INJURY TO PERSONS, OBSERVE THE
FOLLOWING:
A. Use this unit only in the manner intended by the
manufacturer. If you have questions, contact the
manufacturer.
B. Before servicing or cleaning unit, switch power off at service
panel and lock service panel to prevent power from being
switched on accidentally.
When the service disconnecting means cannot be locked,
securely fasten a prominent warning device, such as a tag,
to the service panel.
CAUTION:
For general ventilating use only. Do not use to exhaust
hazardous or explosive materials and vapors.
WARNING: To reduce the risk of fire or electric shock, do not
use this fan with any solid-state speed control.
INSTALLATION INSTRUCTIONS
WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC
SHOCK, OR INJURY TO PERSONS, OBSERVE THE
FOLLOWING:
A. Installation work and electrical wiring must be done by
qualified person(s) in accordance with all applicable codes
and standards, including fire-rated construction.
B. Sufficient air is needed for proper combustion and
exhausting of gases through the flue (chimney) of fuel
burning equipment to prevent back drafting. Follow the
heating equipment manufacturer's guideline and safety
standards such as those published by the National Fire
Protection Association (NFPA), and the American Society for
Heating, Refrigeration and Air Conditioning Engineers
(ASHRAE), and the local code authorities.
FIGURE 1
DUCT COLLAR
HOUSING
SLOTS
POWER UNIT/BLOWER
ASSEMBLY
MOUNTING TAB
TABS
GRILLE
C. When cutting or drilling into wall or ceiling, do not damage
electrical wiring and other hidden utilities.
D. Ducted fans must always be vented to the outdoors.
E. If this unit is to be installed over a tub or shower, it must be
marked as appropriate for the application and be connected
to a GFCI (Ground Fault Circuit Interrupter) protected branch
circuit.
F. NEVER place a switch where it can be reached from a tub or
shower.
COLLIER DE GAINE
BOITER
FENTES
ENSEMBLE MOTEUR/
VENTILATEUR
LA GRILLE
PATTES
PATTES DE MONTAGE
Page view 0
1 2 3 4 5 6

Summary of Contents

Page 1 - Exhaust Fan

READ & SAVE THESE INSTRUCTIONS!INSTALLATION INSTRUCTIONSExhaust FanMODELS: 671R & 672RThe Exhaust Fan consists of the housing, power unit/blow

Page 2 - INSTALLING DUCTWORK

PLANNING DUCTWORK AND WIRINGDuctwork1. Use 4" round duct.2. Plan to run duct from discharge opening of fan to theoutside. For best fan performanc

Page 3 - CONSTRUCTION

POWER/BLOWER UNIT INSTALLATION1. Place power/blower unit into housing so that mountingplate’s tabs insert into slots in housing.2. Press other end of

Page 4 - Ventilateur d’évacuation

LEA Y GUARDE ESTAS INSTRUCCIONES¡INSTRUCCIONES PARA LA INSTALACION!Ventilateur d’évacuationMODELES: 671R et 672RLe ventilateur comprend: le boîter. le

Page 5 - Garantie limitée d’un an

Utilisation de Barres de Suspension(Les barres de suspension sont venduesséparément; commandez le modèle HB4)Voir Figure 3.1. Insérez les barres de su

Page 6 - PARTS LIST

671R, 672RRev.DECEMBER1999CURRENTORIGINAL MODEL USED ONREPLACEMENTREF.PART NO.PART DESCRIPTIONPART NO.1 86863 MOTOR MOUNTING PLATE 671R, 672R 86863-00

Comments to this Manuals

No comments