NuTone WS1 User Manual download pdf (Page 5)

Page 5

ALLURE™ WS1 SERIES

RANGE HOOD

WARNING: To reduce the risk of electric shock,

disconnect from power supply before cleaning.

Aluminum mesh filters: Clean frequently using hot water and a

mild detergent. Filters are dishwasher safe.

Charcoal filters: Clean filter surfaces frequently with a damp cloth

and a mild detergent. DO NOT immerse filters in water or put in

dishwasher. The special “Clean Sense” feature indicates when the

filter is to be replaced. The blue and yellow strips will blend to green

when it is time to change the filter. The “Clean Sense” feature works

best when facing toward the cooking surface.

To clean hood: Remove filters. Use a damp cloth and a mild deter-

gent to wipe all grease-laden surfaces. Use care when cleaning fan

blade - it must not become bent or misaligned. DO NOT ALLOW

WATER TO ENTER MOTOR. Make sure all surfaces are completely

dry before re-installing filters and restoring power.

Motor is permanently lubricated. Do not oil or disassemble motor.

OPERATION

CLEANING

Fan: The 3-position rocker switch (on the left) controls the fan. The

left position is low speed, center position is off, and right position is

high speed. An indicator light shows that the fan is on.

Light: The 3-position rocker switch (on the right) controls the lights.

The left position is low light intensity, center position is off, and right

position is high light intensity.

INSTALL HOOD

KEYHOLE

(4)

MOUNTING

SCREW

(4)

1 Hang hood from (4) Mounting Screws (from parts bag).

Slide hood towards wall until mounting screws are engaged

in narrow end of (4) Keyholes. Tighten mounting screws

securely.

PAR20,

50W MAX.

HALOGEN

BULB (2)

- or -

R16,

40W MAX.

INCANDESCENT

BULB (2)

4 Replace filters and make sure fan blade turns freely. Turn on

power at service panel, and test for proper operation.

2 Connect ductwork to hood. Use Duct Tape to make joints

secure and air tight.

DUCT

TAPE

CAUTION DO NOT PUSH ON FAN BLADE. Pushing on the

blade may cause it to interfere with other hood parts.

3 Install (2) PAR20, 50 W Maximum Halogen Bulbs or (2)

R16, 40 W Maximum Incandescent Bulbs. Purchase bulbs

separately.

CAUTION: Bulbs may be hot! Refer to bulb packaging

for further information.

If hood is to be installed Non-Ducted:

Purchase a set of (2) non-ducted filters from your local distributor or

retailer and attach them to the aluminum mesh filters.

NON-DUCTED FILTERS

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

NuTone WS1 User Manual Page 5

Comments to this Manuals

Related products and manuals for Cooker hoods NuTone WS1